User guide

Release Notes for Cisco 7200/7400 Series Manager Release 1.1 on Solaris

78-14030-01

Documentation Errata

Please note the following on page 2-13 of Installing and Setting Up Cisco

7200/7400 Series Manager on Solaris:

• Disregard Step 3 and proceed to Step 4

• In Step 4, run the uninstall script by entering

CEMF_ROOT/bin/cemf install -r

Caution The command CEMF_ROOT/bin/cemf install -r is not recommended as it

might remove certain shared packages that are required by other Element

Managers installed.

To uninstall Cisco 7200/7400 Series Manager Software:

Step 1 Log in as root.

Step 2 Go to the CERM install directory. This directory contains CERM install files

extracted from Cisco.com.

Step 3 Run the unistall script by entering:

./cerminstall -r

Please note the following on page 1-22 of Cisco 7200/7400 Series Manager User

Guide:

Card Type Not Set

This state applies only to voice cards. It indicates that the voice card has been

discovered and commissioned but is not configured.

A voice card must be configured as a T1 or E1 card. This is not possible until the

card is commissioned. When the voice card is discovered and commissioned, it is

placed in the Card Type Not Set state until the configuration is saved. After the

card is configured, it is moved to the appropriate state (typically Normal).