Specifications

1-11
Cisco 7301 Installation and Configuration Guide
OL-5418-07
Chapter 1 Cisco 7301 Overview
Installing the SFP GBIC Module
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Installing the SFP GBIC Module
Figure 1-6 Inserting a SFP GBIC Module into the Cisco 7301 Gigabit Ethernet Port 0/1
Use the following procedure to install a SFP GBICmodule:
Step 1 Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Step 2 Locate the label on the SFP GBIC module and turn the SFP GBIC module so the label is on top and the
alignment groove is down.
Note The SFP GBIC module is keyed so that it cannot be inserted incorrectly.
Step 3 Insert the SFP GBIC module into SFP GBIC port 0/1, 0/2, or 0/3. The SFP GBIC module snaps into place
when you have completely and properly inserted it.
Step 4 Repeat Step 2 if you are inserting a second or third SFP GBIC module.
Note Do not remove the plug from the SFP GBIC optical bores until you are ready to install the network
interface optical fiber cable. Save the plug for future use.
This completes the SFP GBIC module installation procedure.
1 SFP GBIC port 0/1 2 SFP GBIC module
RJ45 EN
LINK
TX
RX
GBIC
GIGABIT ETHERNET 0/2
ETHERNET 0/0
LINK
TX RX
GBIC
RJ45 EN
LINK
TX RX
GBIC
GIGABIT ETHERNET 0/1
SERIES
CONSOLE
AUX
COMPAC
FLASH
80269
2
TX
RX
TX RX
GBIC
1