Installation guide

5
Release Notes for Cisco uBR7200 Series for Cisco IOS Release 12.1 T
78-10643-04 Rev. B0
Introduction
Release 12.1(3)T
•
Circuit Interface Identification MIB
• Expression MIB Support of Delta,
Wildcarding, and Aggregation
• Individual SNMP
11
Trap Support
• Source Specific Multicast
None
Release 12.1(2)T
•
Enhanced Per Modem Error Counter
• MC16S LED
12
Enhancement
• MPLS
13
VPN
14
Support for Subinterfaces
and Interface Bundles
• SNMP Cable Modem Remote Query
None
Release 12.1(1a)T1
•
Baseline Privacy Interface (BPI) MIB
• Cable Subinterfaces and Interface
Bundling Support for Virtual Private
Networks
• DOCSIS Quality of Service Enhancements
• Dynamic Mobile Hosts
• Enhanced Modem Status Display
• Firewall Enhancements
• Redirect-Number Support for RADIUS
15
and TACACS+
16
Servers
• Upstream Address Verification
Enhancement
• Point-to-Point Wireless
Modem Card and
associated hardware
components
• Cisco Cable Clock Card
• MC16E Cable Modem
Card
• MC16S Cable Modem
Card
1. Only major features are listed. See the Release Notes for each particular release for a comprehensive feature list.
2. DHCP = Dynamic Host Configuration Protocol
3. CLI = command line interface
4. IGMP = Internet Group Management Protocol
5. MSDP = Multicast Source Discovery Protocol
6. MIB = Management Information Base
7. NAT = Network Address Translation
8. NTP = Network Time Protocol
9. PIM = Protocol Independent Multicast
10. PPPoE = Point-to-Point Protocol over Ethernet
11. SNMP = Simple Network Management Protocol
12. LED = light emitting diode
13. MPLS= Multiprotocol Label Switching
14. VPN = Virtual Private Network
15. RADIUS = Remote Access Dial-In User Service
16. TACACS+ = Terminal Access Controller Access Control System Plus
Table 2 Early Deployment Releases for the CiscouBR7200Series Universal Broadband Routers
ED Release Additional Software Features
1
Additional Hardware Features