Specifications

Application View Cisco PIM Application
Device Management Page 97 Cisco Router
CBSR Preference
The preference value for the local interface as a
candidate bootstrap router. A value of -1 is used
to indicate that the local interface is not a
candidate BSR interface. You can set this value in
the PIM Interface Table Entry view (Page 96).
PIM Neighbor Table View
Access: From the Icon Subviews menu for the
CiscoPIMApp Application icon, select Neighbor.
This view provides the PIM Neighbor table,
described below.
PIM Neighbor Table
This table lists the router's PIM neighbors and
contains the following information.
IP Address
The IP address of the PIM neighbor for which this
entry contains information.
IF Index
The value of IF Index for the interface used to
reach this PIM neighbor.
Up Time
The time since this PIM neighbor (last) became a
neighbor of the local router.
Expiry Time
The minimum time remaining before this PIM
neighbor will be aged out.
Mode
The active PIM mode of this neighbor. This field is
deprecated for PIMv2 routers since all neighbors
on the interface must be either dense or sparse as
determined by the protocol running on the
interface. Possible values are dense and sparse.
PIM IPM Route Table View
Access: From the Icon Subviews menu for the
CiscoPIMApp Application icon, select PIM IPM Route.
This view provides the PIM IPM Route table,
described below.
PIM IPM Route Table
This table lists PIM-specific information on a
subset of the rows of the IPM Route Table
(Page 87) and contains the following information.
Group Address
The value of Group Address from the IPM Route
Table (Page 87).
Source Address
The value of Source Address from the IPM Route
Table (Page 87).