Specifications

Application View Cisco PIM Application
Device Management Page 96 Cisco Router
PIM Interface Table View
Access: From the Icon Subviews menu for the
CiscoPIMApp Application icon, select Interface.
This view provides the PIM Interface table as well
as an additional, user-configurable Join Prune
Interval field, both described below.
PIM Interface Table
This table lists the router's PIM interfaces. IGMP
and PIM are enabled on all interfaces listed in this
table. Double-clicking any entry in the PIM
Interface table opens the PIM Interface Table
Entry view, which displays PIM Interface
information for and allows configuration of that
entry. The PIM Interface table contains the
following information.
IF Index
The IF Index value of this PIM interface.
Address
The IP address of the PIM interface.
Net Mask
The network mask for the IP address of the PIM
interface.
Mode
The configured mode of this PIM interface. A
value of sparseDense is only valid for PIMv1.
Possible values are dense, sparse, and
sparseDense. You can set this value in the PIM
Interface Table Entry view (Page 96).
Designated Rtr
The Designated Router on this PIM interface. For
point-to-point interfaces, this field has the value
0.0.0.0.
Hello Interval
The frequency at which PIM Hello messages are
transmitted on this interface. You can set this
value in the PIM Interface Table Entry view
(Page 96).
Status
The status of this entry. Possible values are
active, notInService, notReady, createAndGo,
createAndWait, and destroy. Creating the entry
enables PIM on the interface; destroying the entry
disables PIM on the interface. You can set this
value in the PIM Interface Table Entry view
(Page 96).
Join Prune Interval
The frequency at which PIM Join/Prune messages
are transmitted on this PIM interface. You can set
this value in the PIM Interface Table Entry view
(Page 96), or in the Join Prune Interval field
below the PIM Interface table.