Specifications

Application View Cisco IPM Routing Application
Device Management Page 87 Cisco Router
Cisco IPM Routing Application
This application (CiscIPMRoutApp) provides the
following IP multicasting management views:
• IPM Route Table View
• IPM Route Next Hop Table View (Page 88)
• IPM Route Interface Table View (Page 90)
• IPM Route Boundary Table View (Page 90)
• Cisco IPM Route Table View (Page 91)
• Cisco IPM Route Next Hop Table View
(Page 93)
• Cisco IPM Route Heartbeat Table View
(Page 94)
IPM Route Table View
Access: From the Icon Subviews menu for the
CiscIPMRoutApp Application icon, select Route.
This view provides the IPM Route table as well as
an IPM Route Enable (Page 88) button, both
described below.
IPM Route Table
This table contains the following IP multicast
routing information.
Group Address
The IP multicast group address for which this
entry contains multicast routing information.
Source Address
The network address which when combined with
the corresponding value of Source Mask
(Page 87) identifies the sources for which this
entry contains multicast routing information.
Source Mask
The network mask which when combined with
the corresponding value of Source (Page 87)
identifies the sources for which this entry
contains multicast routing information.
Upstream Neighbor
The address of the upstream neighbor (e.g., RPF
neighbor) from which IP datagrams from these
sources to this multicast address are received, or
0.0.0.0 if the upstream neighbor is unknown (e.g.,
in CBT).
IF Index
The value of IF Index for the interface on which
IP datagrams sent by these sources to this
multicast address are received. A value of 0
indicates that datagrams are not subject to an
incoming interface check, but may be accepted on
multiple interfaces (e.g., in CBT).