Specifications

Application View ATM Client Application
Device Management Page 73 Cisco Router
Oper Status
This object indicates the current operational
status (up, down, or unknown) of the VCL.
Last Change
The value of MIB II’s System Up Time object at the
time this VCL entered its current operational
state. If the current state was entered prior to the
last re-initialization of the agent, then this object
contains a zero value.
Rcv Descr Index
The value of this object identifies the row in the
ATM Traffic Descriptor Table that applies to the
receive direction of this VCL.
Xmit Descr Index
The value of this object identifies the row of the
ATM Traffic Descriptor Table that applies to the
transmit direction of this VCL.
AAL Type
The type of AAL used on this VCC. An instance of
this object only exists when the local VCL
endpoint is also the VCC endpoint, and AAL is in
use.
Transmit Size
The maximum AAL5 CPCS SDU size in octets that
is supported on the transmit direction of this
VCC. An instance of this object only exists when
the local VCL end-point is also the VCC endpoint,
and AAL5 is in use.
Receive Size
The maximum AAl5 CPCS SDU size in octets that
is supported on the receive direction of this VCC.
An instance of this object only exists when the
local VCL end-point is also the VCC endpoint, and
AAL5 is in use.
Encaps Type
The type of data encapsulation used over the
AAL5 SSCS layer. An instance of this object only
exists when the local VCL endpoint is also the
VCC end-point, and AAL5 is in use.
Cross Connect Id
This object is implemented only for a VCL that is
cross-connected to other VCLs that belong to the
same VCC.
Row Status
This object is used to create, delete, or modify a
row in this table. To create a new VCL, this object
is initially set to “createAndWait” or
“createAndGo.”
Row Status Procedure
This procedure provides step-by-step instructions
to create or remove channel information.