Specifications

Application View Cisco Modem Application
Device Management Page 57 Cisco Router
Modulation Scheme Used
The modem modulation scheme used in the
current or previous call. This object exists only for
modems which have the cmManageable object
set to “true.”
Protocol Used
The modem protocol used in the current or
previous call. This object exists only for modems
that have the cmManageable object set to “true.”
TX Rate
The modem transmit rate of the current or
previous call in bits per second. This object exists
only for modems that have the cmManageable
object set to “true.”
RX Rate
The modem receive rate of the current or previous
call in bits per second. This object exists only for
modems that have the cmManageable object set
to “true.”
TXAnalog Signal Level
The modem transmit analog signal level in the
current or previous call. This object exists only for
modems that have the cmManageable object set
to “true.”
RXAnalog Signal Level
The modem receive analog signal level in the
current or previous call. This object exists only for
modems that have the cmManageable object set
to “true.”
Modem Line Configuration Table View
Access: From the Icon Subviews menu for the
CiscoModemApp Application icon, select Line Config
Table.
This table shows objects that describe
configuration information for the modem.
Slot.Port
The chassis slot and port for this entry.
AT Mode Permit
Direct Connect session is used for testing and
debugging purposes by using the modem AT
commands through the out-of-band management
port when cmManageable is set to “true.” This
object specifies whether the Direct Connect
session is permitted to be used at this modem. If
cmManageable is “true” (1), Direct Connect
session via the out of band port is allowed; if
“false” (2), Direct Connect session is not allowed
for the modem.
Status Polling
Modem status and events can be polled through
the out of band management port when the
cmManageable is set to “true.” This object
specifies whether this status polling feature is