Specifications

Application View Cisco STUN Application
Device Management Page 38 Cisco Router
STUN Group View
Access: From the Icon Subviews menu for the
CiscoSTUNApp Application icon, select STUN Group Table.
This view identifies the STUN (Serial Tunneling)
group number and protocol type that Cisco A and
Cisco B use to route SDLC traffic over the IP
network. The table contains an entry for each
STUN group defined on the router.
Group Index
The configured STUN group number.
Protocol Type
The protocol type for this STUN group.
STUN IP Address
The configured IP address used for all serial
tunnelling in this router.
STUN Port View
Access: From the Icon Subviews menu for the
CiscoSTUNApp Application icon, select STUN Port Table.
This view identifies the serial interface to the
SDLC line for which the router is providing serial
tunneling. It also identifies the STUN group that
the interface is in and the default routing for
unrecognized SDLC addresses.
Group Index
The group number to which the STUN port
belongs. Frames will only be routed to other ports
(on this or another router) in the same STUN
group.
Default Peer Type
The type of identification of the default partner for
unrecognized addresses.
Default Peer IP
The IP address of the remote default STUN
partner, for unrecognized addresses.
Default Peer Serial IF
If the STUN Route Type is “serial” then this is the
serial interface index of the point-to-point link to
the remote partner; if STUN Route Type is
“serialDirect” then the partner is in the local
STUN; if STUN Route Type is “ip” then this field is
“0.”