Specifications

Application View Cisco DLSW Application
Device Management Page 146 Cisco Router
DLSw should perform the appropriate action
given its previous state (e.g., send HALT_DL if the
state was connected) to bring the circuit down to
the disconnected state. Both the partner DLSw
and local end station(s) should be notified as
appropriate. Possible values are disconnected,
circuitStart, resolvePending,
circuitPending, circuitEstablished,
connectPending, contactPending, connected,
disconnectPending, haltPending,
haltPendingNoack, circuitRestart, and
restartPending.
Priority
The transmission priority of this circuit as
understood by this DLSw node. This value is
determined by the two DLSw nodes at circuit
startup time. If this DLSw node does not support
DLSw circuit priority, the value unsupported
should be returned. Possible values are
unsupported, low, medium, high, and highest.
FC Send Granted Units
The number of paced SSP messages that this
DLSw is currently authorized to send on this
circuit before it must stop and wait for an
additional flow control indication from the partner
DLSw. The value zero should be returned if this
circuit is not running the DLSw pacing protocol.
FC Send Current Wndw
The current window size that this DLSw is using
in its role as a data sender. This is the value by
which this DLSw would increase the number of
messages it is authorized to send, if it were to
receive a flow control indication with the bits
specifying “repeat window”. The value zero should
be returned if this circuit is not running the
DLSw pacing protocol.
FC Recv Granted Units
The current number of paced SSP messages that
this DLSw has authorized the partner DLSw to
send on this circuit before the partner DLSw
must stop and wait for an additional flow control
indication from this DLSw. The value zero should
be returned if this circuit is not running the
DLSw pacing protocol.
FC Recv Current Wndw
The current window size that this DLSw is using
in its role as a data receiver. This is the number of
additional paced SSP messages that this DLSw
would be authorizing its DLSw partner to send, if
this DLSw were to send a flow control indication
with the bits specifying “repeat window”. The
value zero should be returned if this circuit is not
running the DLSw pacing protocol.