Specifications

Application View Cisco DLSW Application
Device Management Page 127 Cisco Router
Status
The status of the DLSw part of the system.
Changing the value from active to inactive
causes DLSw to take the following actions: (1), it
disconnects all circuits through all DLSw
partners, (2), it disconnects all transport
connections to all DLSw partners, (3), it
disconnects all local DLC connections, and, (4), it
stops processing all DLC connection set-up
traffic.
Changing the value from inactive to active
causes DLSw to come up in its initial state, i.e.,
transport connections established and ready to
bring up circuits.
Up Time
The time (in hundredths of a second) since the
DLSw portion of the system was last re-initialized.
That is, if ciscoDlswstate is in the active state,
the time the ciscoDlswState entered the active
state. It will remain zero if ciscoDlswState is in
the inactive state.
Virtual Segment LF Size
The largest frame size (including DLC header and
info field but not any MAC-level or framing octets)
this DLSw can forward on any path through itself.
This object can represent any box-level frame size
forwarding restriction (e.g., from the use of fixed-
size buffers). Some DLSw implementations will
have no such restriction.This value will affect the
LF size of circuits during circuit creation. The LF
size of an existing circuit can be found in the RIF
(Routing Information Field). Possible values
appear in Table 15 (Page 113).
Resource NB Exclusivity
A value of true indicates that the NetBIOS Names
configured in Dlsw Dir NBIOS Table (Page 141) are
the only ones accessible via this DLSw. If a node
supports sending run-time capabilities exchange
messages, changes to this value should cause
that action. It is up to the implementation exactly
when to start the run-time capabilities exchange.
Resource Mac Exclusivity
A value of true indicates that the MAC addresses
configured in the Dlsw Dir MAC Table (Page 139)
are the only ones accessible via this DLSw. If a
node supports sending run-time capabilities
exchange messages, changes to this value should
cause that action. It is up to the implementation
exactly when to start the run-time capabilities
exchange.
Caution:
Caution:
Since the following are destructive
actions, the user should query the
circuit and transport connection
tables in advance to understand the
effect this action will have.