Specifications

Application View Cisco DLSW Ext Application
Device Management Page 118 Cisco Router
Backup Linger
This variable indicates whether the backup peer
will remain connected after the primary peer
connection has been re-established. True
indicates that the backup peer will remain
connected after the primary peer connection has
been re-established, for the length of time
specified in Backup Linger Int. False indicates that
the backup peer will remain connected until all
circuits on the backup peer connection have been
disconnected. The default value is false.
Backup Linger Int
This variable indicates the length of time the
backup peer remains connected after the primary
peer connection has been re-established. If this
variable is zero, the backup peer will be
disconnected immediately after the primary peer
connection has been re-established. If greater
than zero the backup will stay connected for the
number of minutes indicated by this variable,
after the primary peer connection has been re-
established. Note that the linger interval is only
used when Backup Linger is true.
Priority
Indicator of whether this peer connection
supports priority. When priority is configured for
the remote peer, DLSw+ will automatically
activate four TCP connections to that remote peer
(ports 2065, 1981, 1982, and 1983). Priority only
needs to be configured if you need to prioritize
between SNA and NetBIOS, or within SNA by
LOCADDR or MAC/SAP pair (known as SAP
prioritization). In addition, this granular packet
classification is only possible when TCP
encapsulation is selected for a specific remote
peer. By default DLSw+ assigns certain traffic to
specific TCP ports. The default value is false.
Dest MAC
Permits the peer connection to be established
only when there is an explorer frame destined for
the specified 48-bit MAC address. If no explorer
traffic with a destination address of Dest MAC is
received by DLSw, the peer represented by this
conceptual row will not be connected.
Dynamic
Indicates the peer connection is to be established
only when there is DLSw+ data to send. The
default value is false.