Specifications

Application View Cisco DLSW Ext Application
Device Management Page 115 Cisco Router
Peer TCP Queue Max
Default promiscuous peer maximum output TCP
queue size. For DLSw over TCP encapsulation,
packets may be queued due to congestion of the
TCP network. This variable is used to set the
output queue maximum of the underlying TCP
connection, by default on a promiscuous peer
transport connection.
On Demand Cost
This variable indicates the cost that will be used
with peer on demand peers. If an end station can
be reached through more than one peer, the cost
of each peer will be considered when a circuit is
established. A lower cost indicates that peer will
be the preferred choice if there is more than one
path to the destination.
On Demand FST
This variable indicates if Fast-Sequenced
Transport (FST) will be for peer on demand peers.
True indicates that FST will be used, false
indicates that it will not. The default value is
false.
On Demand Inactivity Int
This variable indicates the length of time a peer
on demand connection can be idle before shutting
down this peer on demand connection. If set to
zero, the peer on demand connection will not be
closed due to inactivity.
On Demand Keep Alive Int
Default peer on demand keepalive interval in
seconds. The keepalive parameter refers to how
often DLSw peers send peer keep alives to each
other. These periodic messages allow DLSw to
keep track of the state of all peers. If set to zero,
no keepalives are sent.
lfs38618 38618
lfs41600 41600
lfs44591 44591
lfs47583 47583
lfs50575 50575
lfs53567 53567
lfs56559 56559
lfs59551 59551
lfs65535 65535
Table 15: Peer LF Size Values (Continued)
Value Largest Frame Size