Specifications

2-2

Cisco 7100 Series VPN Router Installation and Configuration Guide

78-6341-03

Chapter 2 Preparing for Installation

Shipping Container Contents

Ensure that the correct Cisco 7100 series router is in the shipping container. The shipping container

includes the following items:

• Cisco 7100 series router with appropriate port adapter card installed

• A rack-mount and cable-management kit that includes the following items:

–

Two rack-mount brackets for 19-inch rack installations

–

Two rack-mount brackets for 23-inch rack installations

–

One cable-management bracket

–

Sixteen M3.5 x 8-mm Phillips flathead screws for securing the rack-mount brackets to the

chassis

–

Two M3.5 x 7-mm slotted hexhead screws for securing the cable-management bracket to the

chassis

Note Four 10-32 x 3/8-inch slotted binderhead screws are required to secure the chassis to the rack rails; the

binderhead screws are not included in the rack-mount and cable-management kit.

• ESD-preventive wrist strap

• Nylon cable tie

• Cable tie holder

• Ground lug kit that includes two M3.5 x 7-mm screws

• Documentation CD-ROM

• Documentation

–

Cisco 7100 Series VPN Router Documentation flyer

–

Cisco 7100 Series VPN Router Regulatory Compliance and Safety Information

–

A Cisco IOS release note for the software installed on the router

Keep the shipping container in case you must return the router to the factory.

Safety Guidelines

Any device that uses electricity must be handled carefully; follow these guidelines to ensure general

safety:

• Keep the chassis area clear and dust-free during and after installation.

• Put the removed chassis cover in a safe place.

Warning

The safety cover is an integral part of the product. Do not operate the unit without the safety cover

installed. Operating the unit without the cover in place will invalidate the safety approvals and pose

a risk of fire and electrical hazards.

• Keep tools away from walk areas where you and others could fall over them.