Specifications

CHAPTER
2-1
Cisco 7100 Series VPN Router Installation and Configuration Guide
78-6341-03
2
Preparing for Installation
This chapter describes the tasks you must perform before you begin to install a Cisco 7100 series VPN
router and includes the following sections:
• Tools and Parts Required, page 2-1
• Shipping Container Contents, page 2-2
• Safety Guidelines, page 2-2
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
This equipment contains an energy hazard. Disconnect the system before servicing.
Read the installation instructions before you connect the system to its power source.
Tools and Parts Required
Cisco 7100 series routers are fully assembled at the factory; no additional assembly is required prior to
installing the router. The following tools and parts are shipped with Cisco 7100 series routers (unless
noted otherwise) and are required for installation:
• Electrostatic discharge (ESD)-preventive wrist strap
• Number 2 Phillips screwdriver (not included with the router)
• Flat-head screwdriver (not included with the router)
• Rack-mount and cable-management kit for 19- or 23-inch, four-post or telco-type rack installation
• Rubber feet for desktop installation
• One double ground lug and two M3.5 x 8-mm screws for grounding the chassis