Specifications

1-11
Cisco 7100 Series VPN Router Installation and Configuration Guide
78-6341-03
Chapter 1 Overview
Cisco 7120 Series Overview
Cisco 7120-AT3, Cisco 7120-AE3, and Cisco 7120-SMI3
The Cisco 7120-AT3 provides one high-speed, ATM port that supports full-duplex operation at T3
(45-Mbps) speeds. The Cisco 7120-AE3 provides one high-speed, ATM port that supports full-duplex
operation at E3 (34-Mbps) speeds. The Cisco 7120-SMI3 provides one ATM port that supports
full-duplex operation at OC-3c/STM1 single-mode intermediate reach (155-Mbps) speeds.
These models provide the following features:
• Up to 4096 total virtual circuits (open VCs)
• Up to 1024 simultaneous segmentations and reassemblies (SARs)
• ATM adaptation layer 5 (AAL5) for data traffic
• Traffic shaping on a per-VC basis
• IP-to-ATM class of service (CoS)
• Non-real time variable bit rate (nrt-VBR), unspecified bit rate (UBR), and available bit rate (ABR)
quality of service (QoS)
• Operation, Administration, and Maintenance alarm indication signal (OAM AIS) cells
• LAN emulation (LANE)
• User-Network Interface (UNI) signaling
• Integrated Local Management Interface (ILMI)
• Loopbacks
• RFC 1483 and RFC 1577
Figure 1-11 shows the back of the Cisco 7120-AT3. Access to the interfaces is located at the back of the
router.
Figure 1-11 Cisco 7120-AT3—Back View
SLOT 0 SLOT 1
0
2
FE 0 / 0 FE AUX
7120 - AT3
RXTX
DS3
RX
EN
CEL CAR ALM
5
I
CONS
ACT
0 / 1
ACT
LNK
0
LNK
1
PWR
SYS
RDY
Console and
auxiliary ports
Fixed LAN ports Power supply
ATM T3 WAN port
ATM 1/0
18490
LEDs
Modular port adapter
Fast Ethernet 0/0
Fast Ethernet 0/1
PC Card
slots (covered)
Service module