Specifications

4-20
Cisco 7100 Series VPN Router Installation and Configuration Guide
78-6341-03
Chapter 4 Performing a Basic Startup Configuration
Viewing the System Configuration
ROM:System Bootstrap, Version 12.0(4)XE, RELEASED SOFTWARE
BOOTFLASH:EGR Software (c7100-BOOT-M), Released Version 12.0(1990607:041101)
Router uptime is 19 minutes
System restarted by reload
System image file is "c7100-p-mz"
cisco 7120-T3 (EGR) processor with 61440K/69632K bytes of memory.
R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache
Last reset from power-on
X.25 software, Version 3.0.0.
3 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
125K bytes of non-volatile configuration memory.
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2000
Use the show diag command to determine what types of port adapters are installed in the router. You
can also use the show diag slot command to display information about a specific port adapter slot.
The following example shows the show diag command output from a Cisco 7120-T3:
Router# show diag
Slot 0:
10/100 Fast-ethernet with RJ45 Integrated port adapter, 2 ports
Integrated port adapter is analyzed
EEPROM contents at hardware discovery:
Hardware revision 1.0 Board revision A0
EEPROM format version 1
EEPROM contents (hex):
0x20:01 D3 01 00 00 A4 19 EC 49 06 98 04 00 00 00 00
0x30:50 00 00 00 98 10 21 00 FF FF FF FF FF FF FF FF
Slot 1:
T3 PA Integrated port adapter, 1 port
Integrated port adapter is analyzed
EEPROM contents at hardware discovery:
Hardware revision 1.0 Board revision A0
EEPROM format version 1
EEPROM contents (hex):
0x20:01 70 01 00 00 BD 14 80 49 0A 38 02 00 00 00 00
0x30:50 00 00 00 99 03 09 00 FF FF FF FF FF FF FF FF
Slot 3:
Fast-ethernet (TX-ISL) Port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time 00:20:37 ago
EEPROM contents at hardware discovery:
Hardware revision 1.0 Board revision A0
Serial number 10754540 Part number 73-1688-04
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20:01 11 01 00 00 A4 19 EC 49 06 98 04 00 00 00 00
0x30:50 00 00 00 98 10 21 00 FF FF FF FF FF FF FF FF
Use the show c7100 command to show the contents of the EPROM. The show c7100 command is used
mainly for diagnostic purposes. Following is show c7100 command sample output from a
Cisco 7140-2T3:
Router# show c7100
Network IO Interrupt Throttling:
throttle count=0, timer count=0