Specifications

4-18
Cisco 7100 Series VPN Router Installation and Configuration Guide
78-6341-03
Chapter 4 Performing a Basic Startup Configuration
Saving the Running Configuration to NVRAM
no ip address
no ip directed-broadcast
shutdown
framing c-bit
cablelength 10
dsu bandwidth 44210
!
interface Serial1/1
no ip address
no ip directed-broadcast
shutdown
framing c-bit
cablelength 10
dsu bandwidth 44210
!
interface FastEthernet4/0
no ip address
no ip directed-broadcast
shutdown
!
router igrp 200
network 10.0.0.0
!
ip classless
no ip http server
!
!
map-list atm1
!
!
line con 0
exec-timeout 0 0
transport input none
line aux 0
line vty 0 4
login
!
end
Checking the Interface Configurations
You can identify interfaces by using software commands:
• Use the show interfaces command to display information about all interfaces
• Use the show interfaces command with the interface type (Ethernet, Token Ring, ATM, and so
forth), slot number, and port number in the format show interfaces type slot/port to display
information about a specific interface
The following examples show the display for the Fast Ethernet port 0 in slot 0:
Router# show interfaces fastethernet 0/0
FastEthernet0/0 is up, line protocol is up
Hardware is DEC21140A, address is 0050.73ff.6300 (bia 0050.73ff.6300)
Internet address is 10.0.0.0
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliablility 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 10Mb/s, 100BaseTX/FX
ARP type:ARPA, ARP Timeout 04:00:00
Last input 00:00:04, output 00:00:03, output hang never