Specifications

4-4
Cisco 7100 Series VPN Router Installation and Configuration Guide
78-6341-03
Chapter 4 Performing a Basic Startup Configuration
Configuring a Router
Performing a Basic Configuration Using the Setup Facility
If you do not plan to use AutoInstall, do not connect the router’s serial (WAN) cable to the network. The
router boots from Flash memory and goes automatically into the setup facility, if the WAN interface is
not connected.
You can run the setup facility any time you are at the privileged-level (enable) prompt (#) by entering
the command setup.
Note If the router does not have a configuration stored in NVRAM, the router attempts to run AutoInstall at
startup. After the router determines that AutoInstall is not configured, it defaults to the setup facility.
Configure the global parameters and interface parameters, if you have not already done so (see “Using
the EXEC Command Interpreter” section on page 4-8). Global parameters are used for controlling
system-wide settings. Interface parameters are used to create a connection over a LAN or WAN.
Complete the following steps to perform a basic configuration using the setup facility:
Step 1 Ensure that a console terminal is connected to the console port, and then boot the router.
The system boots from Flash memory. The following information appears after about 30 seconds. When
you see this information, you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) EGR Software (c7100-P-M), Released Version 12.0(4)XE
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 07-Jun-99 10:25 by biff
Image text-base:0x600088F8, data-base:0x60A54000
cisco 7140-2T3 (EGR) processor with 61440K/69632K bytes of memory.
R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Last reset from power-on
X.25 software, Version 3.0.0.
3 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
125K bytes of non-volatile configuration memory.
40960K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
4096K bytes of Flash internal SIMM (Sector size 256K).
Press RETURN to get started!