Specifications

1.3 TECHNOLOGY
MEMORY
The system operates using stored program control.This program is stored on a NAND Flash memory.The memo-
ry also provides space for a backup customer database and approximately 14 hours of voicemail storage.The cus-
tomer database is stored indefinitely in NAND Flash. Call Logs, Alarms, UCD call statistics, program logs and traf-
fic reports are stored in NAND flash. No on/off battery switch is required for the OfficeServ 7030 main unit.
MICROPROCESSORS
OfficeServ 7030 uses distributed processing. The primary processor operates at a clock speed of 375 MHz. This
provides all the main processing necessary for the system. The tertiary level of processing is done in the keysets.
The digital keysets use a Hitachi H8 processor for data communication within the system.
1.4 PROGRAMMING
The OfficeServ 7030 is a self-configuring system. This means that immediately after applying power, the
OfficeServ 7030 reads the types and locations of all installed interface cards and keysets and assigns default data
to them. This data provides for system operation within a few minutes after applying power. All trunks and sta-
tions are assigned three digit numbers according to the default numbering plan. This numbering plan is flexible
and may be changed to suit customer requirements. The installing technician customizes this default data to
meet the end user’s requirements.The system comes up default in a 4 CO line by 8 station squared configuration,
with Caller ID enabled and 2 ports of voicemail/auto attendant.Voicemail ports require a license key.
The OfficeServ 7030 also provides a proprietary application called Installation Tool (IS Tool). This application can
be loaded onto any high performance PC (that meets the minimum requirements) and the application is used
only to program the telephone system from anywhere in the world,provided there is a LAN/WAN or modem con-
nection.
This permits technicians to program the phone system, modify the customer database, or download (save) the
entire customer database to a file. This file can be saved as a back up and can be uploaded when required to
restore the database. The IS Tool can also be used to view the customer database offline, and to send new loads
of software upgrades to the media card in a live system.
The system can be programmed from any IP or digital two line display keyset without interrupting system oper-
ation.There are three levels of programming: technician, customer, and station. The technician level has access to
all programs and can allow the customer access to system programs as needed.Technician and customer access
levels are controlled by a different security pass codes and access procedure.
The OfficeServ 7030 provides a proprietary Web based program called Web Management for programming
embedded voicemail/AA. It allows programming from any where in the world provided there is a LAN/WAN con-
nection to the OfficeServ 7030. The Web Management program runs is embedded in the system and uses
Internet Explorer V6.0 or higher as its interface. This permits a technician to program the voicemail/AA using a
personal computer. Use Web Management on-site to modify the customer database (VM/AA only) or to down-
load (save) the entire customer database (VM/AA only). Through the use of LAN or WAN connection, an PC can
access the OfficeServ 7030 system remotely (off-site) to make database changes or perform uploads or down-
loads of the customer database as if the technician were on-site.The OfficeServ 7030 and its daughter cards are
not compatible with other OfficeServ systems and cannot be expanded.
1.7
Home Page