Specifications

4-18
PA-8E 10BaseT Ethernet Port Adapter Installation and Configuration
OL-3494-04
Chapter 4 Configuring the PA-8E
Checking the Configuration
VIP in Cisco 7000 Series Routers and Cisco 7500 Series Routers—Example Output of the show diag Command
Following is an example of the show diag command that shows a PA-8E installed in port adapter slot 0
on a VIP2 in interface processor slot 4:
Router# show diag 4
Slot 4:
Ethernet port adapter, 8 ports
Port adapter is analyzed
Port adapter insertion time 2d09h ago
Hardware revision 1.14 Board revision A0
Serial number 4294967295 Part number 73-1556-04
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20:01 01 01 0E FF FF FF FF 49 06 14 04 00 00 00 00
0x30:50 00 00 00 FF FF FF FF FF FF FF FF FF FF FF FF
Slot database information:
Flags: 0x4 Insertion time: 0x1DEC (2d00h ago)
Controller Memory Size: 8 MBytes
PA Bay 1 Information:
Ethernet PA, 8 ports
EEPROM format version 1
HW rev 1.1, Board revision 80
Serial number: 02825590 Part number: 73-1391-04
Note For complete VIP command descriptions and examples, refer to the publications listed in the “Related
Documentation” section on page viii.
Using the show interfaces Command
Display s status information (including the physical slot and interface address) for the interfaces you
specify using the show interfaces command.
With the show interfaces command, use arguments such as the interface type (ethernet, and so forth)
and the port adapter and port numbers (port adapter/port) to display information about a specific Ethernet
10BaseT interface only.
For complete descriptions of interface subcommands and the configuration options available for the
individual platforms, refer to the publications listed in the “Related Documentation” section on
page viii.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.