Specifications

4-7
PA-8E 10BaseT Ethernet Port Adapter Installation and Configuration
OL-3494-04
Chapter 4 Configuring the PA-8E
Configuring the PA-8E Interfaces
Step 6 Re-enable interfaces by doing the following:
a. Repeat Step 3 to re-enable an interface. Substitute the no shutdown command for the shutdown
command.
b. Repeat Step 4 to write the new configuration to memory. Use the
copy running-config startup-config command.
c. Repeat Step 5 to verify that the interfaces are in the correct state. Use the show interfaces command
followed by the interface type and interface address of the interface.
For complete descriptions of software configuration commands, refer to the publications listed in the
“Related Documentation” section on page viii.
Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router
show interfaces ethernet,
followed by slot/port
(module-slot-number/
interface-port-number)
The example is for interface 0 on a port
adapter in a Cisco 7304 PCI Port Adapter
Carrier Card in module slot 3 of a Cisco 7304
router.
Router# show interfaces ethernet 3/0
Ethernet 3/0 is administratively down,
line protocol is down
[Additional display text omitted from
this example]
Cisco 7401ASR router show interfaces ethernet,
followed by slot/port
(port-adapter-slot-number/
interface-port-number)
The example is for interface 0 on a
port adapter in port adapter slot 1.
Router# show interfaces ethernet 1/0
ethernet 1/0 is administratively down,
line protocol is down
[Additional display text omitted from
this example]
VIP in Cisco 7000 series routers or
Cisco 7500 series routers
show interfaces ethernet,
followed by slot/port adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
The example is for interface 0 on a port
adapter in port adapter slot 1 of a VIP in
interface processor slot 1.
Router# show interfaces ethernet 1/1/0
ethernet 1/1/0 is administratively
down, line protocol is down
[Additional display text omitted from
this example]
Table 4-2 Examples of the show interfaces ethernet Command for the Supported Platforms (continued)
Platform Command Example