Specifications

4-4
PA-8E 10BaseT Ethernet Port Adapter Installation and Configuration
OL-3494-04
Chapter 4 Configuring the PA-8E
Configuring the PA-8E Interfaces
Cisco uBR7223 router interface, followed by the type
(ethernet) and slot/port
(port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
port adapter in port adapter slot 1.
Router(config-if)# interface ethernet 1/0
Router(config-if)# shutdown
Router(config-if)# interface ethernet 1/1
Router(config-if)# shutdown
Ctrl-Z
Router#
Cisco uBR7246 router interface, followed by the type
(ethernet) and slot/port
(port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
port adapter in port adapter slot 2.
Router(config-if)# interface ethernet 2/0
Router(config-if)# shutdown
Router(config-if)# interface ethernet 2/1
Router(config-if)# shutdown
Ctrl-Z
Router#
Cisco 7301 router interface, followed by the type
(ethernet) and slot/port
(port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
port adapter in port adapter slot 1.
Router(config-if)# interface ethernet 1/0
Router(config-if)# shutdown
Router(config-if)# interface ethernet 1/1
Router(config-if)# shutdown
Ctrl-Z
Router#
Cisco 7304 PCI Port Adapter
Carrier Card in a Cisco 7304
router
interface, followed by the type
(ethernet) slot/port
(module-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
port adapter in a Cisco 7304 PCI Port Adapter
Carrier Card in module slot 3 of a Cisco 7304 router.
Router(config-if)# interface ethernet 3/0
Router(config-if)# shutdown
Router(config-if)# interface ethernet 3/1
Router(config-if)# shutdown
Ctrl-Z
Router#
Cisco 7401ASR router interface, followed by the type
(ethernet) and slot/port
(port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 0 and interface 1 on a
port adapter in port adapter slot 1.
Router(config-if)# interface ethernet 1/0
Router(config-if)# shutdown
Router(config-if)# interface ethernet 1/1
Router(config-if)# shutdown
Ctrl-Z
Router#
VIP in Cisco 7000 series routers
or Cisco 7500 series routers
interface, followed by the type
(ethernet) and slot/port
adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
shutdown
The example is for interface 1 and interface 0 on a
port adapter in port adapter slot 1 of a VIP installed
in interface processor slot 1.
Router(config-if)# interface ethernet 1/1/1
Router(config-if)# shutdown
Router(config-if)# interface ethernet 1/1/0
Router(config-if)# shutdown
Ctrl-Z
Router#
Table 4-1 Syntax of the shutdown Command for the Supported Platforms (continued)
Platform Command Example