Specifications

8
Cisco Aironet Series 702W Access Point Deployment Guide, Release 7.6.100.120
AP-702W
AP-702W Powering Options
The AP-702W is designed to accept power via Power over Ethernet (PoE) or by using a local “brick”
style power supply. Because the AP-702W has the ability to provide PoE out on port #4, the unit does
draw in an excess of 15.4 Watts (802.3af) specification, and therefore it is recommended that PoE+,
802.3at or local power supply Cisco part number AIR-PWR-C be used.
Note If the unit is powered by 802.3at (PoE+) then the device draws 16.1 Watts and can deliver PoE out of
port 4 at 7 Watts output. If 802.3af (15.4 Watts) is desired, then the local power supply AIR-PWR-C must
be used.
Table 1 PoE Requirements – if you are using PoE out on PORT 4, PoE+ or local power supply is
required
Description
AP
Functionality
PoE Budget
(Watts) 802.3af E-PoE
802.3at PoE+
PWRINJ4
702W
PoE+
802.3at
702W - Out
of the box
2x2:2 (both
bands) all
ports on
including
PoE OUT
16.1 No Yes Yes
PoE 802.3af 702W - Out
of the box
PoE OUT on
Port 4 is
disabled
(port is
enabled, but
without
PoE). This is
the green
port on AP
2x2:2 in both
bands.
15.4 Yes N/A N/A