Specifications

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Routing Mode Procedures
5-10
Cisco 600 Series Installation and Operation Guide
78-11190-01
Step 4
Reboot the Cisco 67x:
reboot
Note
After you disable the PPP routing feature, you must manually
configure the Cisco 67x.
Changing PPP Routing
These commands change the components of PPP routing:
•
set dhcp server pool
•
set dhcp client -interface
•
set nat entry add
•
set nat entry delete
•
set nat timeout
•
set nat outside -ip
For a complete description of each of these commands, see the
Cisco Broadband
Operating System User Guide
.
RFC 1483 Routing
If you disable PPP routing, see the following steps for RFC 1483 routing: from
the “
Configure the Ethernet Port (eth0)” section on page 5-11 through the
“
Evaluate System Activity and Performance” section on page 5-48.