Specifications

Chapter 4 Configuration Procedures for the Cisco 633

Update the CBOS Prompt

4-8

Cisco 600 Series Installation and Operation Guide

78-11190-01

Step 11

To reboot, enter:

Update the CBOS Prompt

The default Cisco 633 system prompt is

cbos>

. The command prompt is limited

to 8 characters. You can change this prompt to a unique subscriber identifier as

shown in the following example.

Step 1

Log on to CBOS using either the serial or Telnet interfaces.

Step 2

To change the default prompt to 4412883 as the subscriber identifier, enter:

cbos# set prompt 4412883

4412883#

Step 3

To save your changes, enter:

4412883# write

Step 4

To exit CBOS, enter:

4412883# quit

Set Passwords

After you have configured your system, you should pick new passwords for both

the

enable

and

exec modes

. Keep in mind that the

enable

mode provides all the

functionality of a system administrator for the CPE. Examples of good and bad

passwords are:

•

Good Password—77ta99y (Do not use the sample password.)

•

Bad Passwords—Passwords such as your name; or your street address, or

home telephone number are too predictable.