Specifications

4-5
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 4 Configuration Procedures for the Cisco 633
Configure the Cisco 633 for Remote Management
Step 4
Configure a netmask address for the WAN0-0 interface:
set int wan0-0 mask 255.255.255.0
Step 5
Add a static IP route to and from the remote network. This allows data to pass
between your Cisco 633 and the remote network.
set route add ip x.x.x.x gw wan0-0
where
x.x.x.x
is the static IP route to and from the remote network.
Note
You must add a static route or you will not be able to pass
data.
Step 6
To Telnet to the Cisco 633, enable the Telnet application:
set telnet enabled
Step 7
To use the Trivial File Transfer Protocol (TFTP) to transfer files to and from the
Cisco 633, enable the TFTP application:
set tftp enabled
Step 8
To save your changes, enter:
write
Step 9
To reboot the CPE, enter:
reboot
The Cisco 633 is now configured for remote management. Now the FR router (for
example, a Cisco 1600) needs to be configured to pass management data. See the
following section for more information.
Attention Back-to-Back Connection Users
The back-to-back configuration between two Cisco 633 units allows one
Cisco 633 to act as CO equipment and terminate traffic initiated by another
Cisco 633.