Specifications

3-13
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 3 Configuration Procedures for the Cisco 627
Configure Line Coding
Step 5
To erase sector 0, enter:
es 0
Repeat this step for sectors 1 through 5.
Step 6
To start serial download, enter:
df 10008000
Step 7
Use a terminal emulation application, such as Hyperterminal, to start an Xmodem
download of a new Cisco 67x image.
Step 8
When the download is complete, the following message appears:
Transferred xxxxxxxx bytes
Record the number of bytes transferred.
Step 9
To program the area of memory to Flash, enter:
pb 10008000 fef00000
xxxxxxxx
where
xxxxxxxx
is the value recorded in Step 6.
Step 10
To turn debug monitor off, enter:
m0
Step 11
To reboot, enter:
rb
Configure Line Coding
The Cisco 627 allows you to choose transmission protocols to match your network
configuration by changing the CPE’s configuration file and operating system. You
will use the TFTP to transfer files to and from the CPE. This section describes
procedures to configure the Cisco 627 for G.Lite and G.DMT protocols.
Note
Changes to your CPE must be coordinated with the central office
equipment.