Specifications

3-5
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 3 Configuration Procedures for the Cisco 627
Configure Management Virtual Connections
LOS Retrains: 0
LOF/RFI Retrains: 0
ES Events: 0
Time Trained (h:m:s) 0:00:16
Trained...
Step 4
To save the new WAN port configuration, enter:
cbos# write
Step 5
To exit CBOS, enter:
cbos# quit
Note
To close an ATM management connection, enter:
set interface atm
x
disable
. To set the ATM25 management VPI, repeat the previous
steps substituting
atm0
for
atm1
.
Changing VCI Settings
Step 1
To set the VCI number to 32, enter:
cbos# set interface atm0 vci 32
To verify your setting:
cbos# show interface atm0
A display similar to the following will appear on your screen:
atm0 RFC1483 Ethernet Hwaddr 00:E0:D0:01:19:7F
IP address 192.168.1.100 Mask 255.255.255.0
MTU 1500 Metric 0
RX packets 0 errors 0
TX packets 0 errors 0
Port is currently disabled with no link status
VCI 32 VPI 0
Step 2
To begin using this connection with the new settings, enter:
cbos# set interface atm0 enable