Specifications

2-3
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 2 Installation Procedures
Hardware Requirements
Hardware Requirements
The following hardware is necessary to configure the Cisco 600 series CPE:
•
PC with a standard terminal emulation program or a dumb terminal, with a
DB-9 COM port.
Note
If only a DB-25 serial port is available on the computer,
a DB-9-male-to-DB-25-female adapter is also needed to
connect the management cable to the computer.
•
Management cable (RJ-45-to-DB-9) like the one in Figure 2-1 to connect the
CPE to the PC or dumb terminal you will use to configure it. You can order
one from Cisco or provide your own. See Appendix A, “Connectors”
for
information on connector pin assignments.
Figure 2-1 Management Cable
Set Up the Hardware Environment
This section describes how to connect the Cisco 600 series CPE.
18429