Specifications

A-7
Cisco 600 Series Installation and Operation Guide
78-11190-01
Appendix A Connectors
Rear Panel Connectors
Figure A-7 Front View of ATM25 Connector
Management Interface
The management port uses an RJ-45 connector.
If you are not using a management cable ordered from Cisco, use the pinouts in
Table A-5 for the DB-9 end of the serial cable used to connect the management
port to the serial port of the PC.
Management Port Pinouts
Table A-5 shows the connector pinouts for the management port and the DB-9 end
of the serial cable.
Pin 1
Pin 8
18426
Table A-5 Management Connector Pinouts
Signal
Management
Port (RJ-45 Pin)
RJ-45-to-DB-9
Serial Cable
(DB-9 Pin) Signal
Do not connect 1 1 Do not connect
Do not connect 2 4 Do not connect
Do not connect 3 6 Do not connect
Ground 4 5 Ground