Specifications

Chapter 6 Troubleshooting
ADSL Parameters for the set interface command
6-4
Cisco 600 Series Installation and Operation Guide
78-11190-01
ADSL Parameters for the set interface command
The
set interface wan0
command supports these parameters:
Frequently Asked Questions about the WAN LNK LED
The WAN LNK LED blink patterns indicate the connection state of the CPE.
baud []
Allows the ADSL line rate to train at the highest rate
possible.
looptimeout[]
Enter a time for the length of time in seconds required for
a faulty line to cause a retrain event.
overhead-framing
mode-
number
Configures the requested ATM framing structure. The
Cisco 600 series CPE supports ATM overhead framing
mode 3. A retrain is required to negotiate the new
overhead framing mode with the central office equipment.
This parameter only applies to DMT Issue 2 encoding.
This command can be saved in NVRAM.
stay
Sets stay-trained mode. ADSL line will not retrain.
trellis-coding
{enabled |
disabled}
Configures the device to request trellis coding on the wan0
interface. Trellis coding can be enabled or disabled. A
retrain is required to negotiate trellis coding with central
office equipment. Trellis coding must also be enabled on
the DSLAM for it to be enabled. This parameter only
applies to DMT Issue 2 encoding. This command can be
saved in NVRAM.
Note
Do not enable trellis coding on the Cisco 677.