Specifications

5-43
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Static NAT
Step 9
To program the area of memory to Flash, enter:
pb 10008000 fef00000 xxxxxxxx
where
xxxxxxxx
is the value recorded in Step 6.
Step 10
To turn debug monitor off, enter:
m0
Step 11
To reboot, enter:
rb
Configure Static NAT
Prior to following these steps, contact your application vendor to find out which
ports they use.
Step 1
At the command prompt of the CPE, enter:
cbos#enable
Step 2
Enter:
set nat entry add inside-ip-addr inside-port outside-ip-addr
outside-port protocol
where
protocol
is UDP, TCP or ICMP. The default local CPE services ports are:
Service Protocol Port
Telnet TCP 23
TFTP UDP 69
SNMP UDP 161
Web Server TCP 80