Specifications

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Line Coding (Cisco 677 and Cisco 678 only)
5-36
Cisco 600 Series Installation and Operation Guide
78-11190-01
cbos#show version
Cisco Broadband Operating System
CBOS (tm) 025 - Release Software
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Dec 21 1999 20:37:27
DMT firmware version 210
NVRAM image at 0x10356930
Configure for G.Lite
Before the CPE can be configured for G.Lite, it must first be configured for DMT.
In addition, the central office hardware must be correctly configured to accept a
G.Lite service user.
Step 1
Configure the CPE for DMT. See the “Configure for DMT” section on page 5-34.
Step 2
Enter:
cbos# set interface wan0 standard g.lite
Step 3
Be sure to retrain the CPE to activate the new line code. When the CPE is
retrained, use the
show interface wan0
command to verify the G.Lite standard is
active.
Note
Changes made to the running configuration must be written
to NVRAM for changes to be seen on reboot.
Sample Output of Configuration Session for G.Lite
cbos#set interface wan0 standard
SET INTERFACE WANx STANDARD requires one of the following arguments
T1.413
G.lite (G992.2)
cbos#set interface wan0 standard g.lite
Note: Change will take effect on next retrain.