Specifications

5-35
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Line Coding (Cisco 677 and Cisco 678 only)
Substitute the filename for the software image update. Files use the naming
format c67
y
dmt.
x.x.x.x
.bin where 67
y
is the CPE model number, and
x.x.x.x
is the
image version number.
Caution
Do not turn off the power to the router until after the file transfer is
completed.
Step 5
Be sure to reboot the CPE to activate the new image. When you log back in to the
CPE after the reboot, use the
show version
command to verify the version of the
firmware that is active. Note the DMT firmware version.
Sample Output of Configuration Session for DMT
cbos#set tftp enabled
TFTP is enabled
cbos#tftp -i 10.9.1.20 get c678dmt.2.3.5.012.bin
Starting download...
Downloading in progress...... done.
Saving image...........done.
Please reboot the CPE for the new downl
cbos#reboot
Hello!
C67x self-update code: Release 2.3.5.012
NOTE: Do not power off router until update is finished!
Decompressing router...
Erasing FLASH......
Programming...
Decompressing monitor...
Erasing FLASH.........
Programming...
Finished. Rebooting...
Hello!
Expanding CBOS image...
CBOS v2.3.5.012 - Release Software
User Access Verification
Password:
cbos>enable
Password: