Specifications

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Line Coding (Cisco 677 and Cisco 678 only)
5-32
Cisco 600 Series Installation and Operation Guide
78-11190-01
Step 3
Set the remote address for the TFTP host computer:
cbos # set tftp remote ip address
This command tells the CPE to accept TFTP transfers from a specific IP address.
An example remote IP address would be
192.168.35.4.
This address is an example
only; do not use it to configure the router.
Note
If you do not have the CPE address, consult your network
administrator.
For more information about TFTP, see the “
TFTP Server”
section on page 5-27.
Step 4
To start the file transfer from a PC, start a DOS session and enter the following
command:
C:>tftp –i CPE IP address put image_filename
Where necessary, implement the following values:
To start the file transfer from a UNIX machine, enter:
root@staten-</678>tftp
tftp> mode binary
tftp> put CPE IP address:image_filename
Sent 922294 bytes in 54.9 seconds
Substitute the file name for the software image update. Files use the naming
format c67
y
cap.
x.x.x.x
.bin, where 67
y
is the CPE model number, and
x.x.x.x
is the
image version number.
Caution
Do not turn off the power to the router until after the file transfer is
completed.
-i
Sets the transfer mode to binary mode
put
Uploads a file onto that IP address