Specifications

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-22
Cisco 600 Series Installation and Operation Guide
78-11190-01
where
cisco
is the PPP login and
is_great
is the password.
Step 5
Use the
show radius
command to display the Cisco 67x default configuration for
RADIUS.
Note
The RADIUS test command
set radius test
activates the
RADIUS debug option. This allows you to test that RADIUS
works with current client settings by sending a test message
to the RADIUS server.
For more information on RADIUS commands, see the
Cisco Broadband
Operating System User Guide
.
SNMP
To configure SNMP settings, enter the following command from
enable
mode:
set snmp enabled | disabled | remote
remote-address
| traps
host-address
where
The following example command uses hypothetical IP addresses to demonstrate
the use of the
set snmp
command:
set snmp remote 198.162.2.57
set snmp traps 198.162.2.50
disabled
Disables SNMP settings
enabled
Enables SNMP settings
remote
remote-address
Specifies the IP address for the remote
location running SNMP
traps
host-address
Sets the IP address of the host on which
to trap SNMP messages