Specifications

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-20
Cisco 600 Series Installation and Operation Guide
78-11190-01
NAT
The NAT application converts IP addresses on a private network (designated as
“inside” or “LAN”) to global IP addresses that can forward packets to another
registered network (designated as “outside” or “WA N ”). To enable NAT:
Step 1
Enable NAT:
set nat enabled
Step 2
To check whether this feature is enabled, enter:
show nat
Step 3
Write the changes to NVRAM:
write
Step 4
Reboot the Cisco 67x:
reboot
For more information on using NAT, see the
set nat
series of commands in
Cisco
Broadband Operating System User Guide
.
RADIUS Client
RADIUS authenticates users for access to a network. The RADIUS server uses an
authentication scheme, such as PAP, to authenticate incoming messages from
RADIUS clients. When a password is present, it is hidden using a method based
on the RSA Message Digest Algorithm MD5 [1].
The Cisco 67x has been successfully tested for compatibility with the following
RADIUS server providers:
•
Livingston Enterprises RADIUS 2.01
•
Merit RADIUS (Sun binary)
•
RADIUS NT (Microsoft)