Specifications

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-18
Cisco 600 Series Installation and Operation Guide
78-11190-01
Configure Applications
The Cisco 67x supports these applications for system management and control:
•
DHCP client
•
DHCP server
•
NAT
•
RADIUS client
•
SNMP
•
SYSLOG client
•
Telnet server
•
TFTP server
•
Web server (HTTP server)
DHCP Client
The DHCP client requests an IP address from a DHCP server. To enable the DHCP
client:
Note
Enabling the DHCP client automatically disables the DHCP server
on the CPE.
Step 1
Enable the DHCP client:
set dhcp client enabled
Step 2
To change the DHCP client interface, enter:
set dhcp client interface eth0
Step 3
To check whether this feature is enabled, enter:
show dhcp client
Step 4
Write the changes to NVRAM:
write