User guide

5-47
Cisco 600 Series Installation and Operation Guide
78-11190-01
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Set Passwords
Step 4 To save your changes, enter:
write
Step 5 To exit the CBOS, enter:
quit
Set Passwords
After you have configured your Cisco 67x, select and configure new passwords
for both the enable and exec modes. Examples of good and bad passwords are:
• Good Password: 77ta99y (Do not use the sample password.)
• Bad Passwords: Names, personal identification numbers, birthdates,
addresses, home telephone numbers.
Use the set password command to change both the enable and exec user
passwords:
Step 1 To change the enable user password, enter:
set password enable new password
Step 2 To change the exec user password, enter:
set password exec new password
Step 3 To save your changes, enter:
write
Step 4 To exit the CBOS, enter:
quit