User guide

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-26
Cisco 600 Series Installation and Operation Guide
78-11190-01
Note See the Cisco Broadband Operating System User Guide for more
information about how to set and change passwords.
Notice to Windows Users
The Windows Telnet client does not support NVT (Network Virtual Terminal) or
any extra form of option negotiation. However, if you are going to use the
Windows Telnet client, follow these steps to set your terminal settings.
Step 1 When the Telnet window appears, access the Preferences menu in Telnet by
selecting Preferences from the Terminal drop-down menu. (See Figure 5-2.)
Figure 5-2 Telnet Preferences
Step 2 Set the terminal settings on the Terminal Preferences menu to the values shown in
Figure 5-3, then click OK.
Figure 5-3 Telnet Preferences
Notice to Linux Users
If you try to run Linux without installing the Term/Termcap database, the message
BAD ADDRESS displays during a connection attempt. To install the
Term/Termcap database, check the original Linux installation disks.