User guide
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-22
Cisco 600 Series Installation and Operation Guide
78-11190-01
where cisco is the PPP login and is_great is the password.
Step 5 Use the show radius command to display the Cisco 67x default configuration for
RADIUS.
Note The RADIUS test command set radius test activates the
RADIUS debug option. This allows you to test that RADIUS
works with current client settings by sending a test message
to the RADIUS server.
For more information on RADIUS commands, see the Cisco Broadband
Operating System User Guide.
SNMP
To configure SNMP settings, enter the following command from enable mode:
set snmp enabled | disabled | remote remote-address | traps host-address
where
The following example command uses hypothetical IP addresses to demonstrate
the use of the set snmp command:
set snmp remote 198.162.2.57
set snmp traps 198.162.2.50
disabled Disables SNMP settings
enabled Enables SNMP settings
remote remote-address Specifies the IP address for the remote
location running SNMP
traps host-address Sets the IP address of the host on which
to trap SNMP messages