User guide

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-18
Cisco 600 Series Installation and Operation Guide
78-11190-01
Configure Applications
The Cisco 67x supports these applications for system management and control:
• DHCP client
• DHCP server
• NAT
• RADIUS client
• SNMP
• SYSLOG client
• Telnet server
• TFTP server
• Web server (HTTP server)
DHCP Client
The DHCP client requests an IP address from a DHCP server. To enable the
DHCP client:
Note Enabling the DHCP client automatically disables the DHCP server
on the CPE.
Step 1 Enable the DHCP client:
set dhcp client enabled
Step 2 To change the DHCP client interface, enter:
set dhcp client interface eth0
Step 3 To check whether this feature is enabled, enter:
show dhcp client
Step 4 Write the changes to NVRAM:
write