User guide

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Routing Mode Procedures
5-10
Cisco 600 Series Installation and Operation Guide
78-11190-01
Step 4 Reboot the Cisco 67x:
reboot
Note After you disable the PPP routing feature, you must manually
configure the Cisco 67x.
Changing PPP Routing
These commands change the components of PPP routing:
• set dhcp server pool
• set dhcp client -interface
• set nat entry add
• set nat entry delete
• set nat timeout
• set nat outside -ip
For a complete description of each of these commands, see the Cisco Broadband
Operating System User Guide.
RFC 1483 Routing
If you disable PPP routing, see the following steps for RFC 1483 routing: from
the “Configure the Ethernet Port (eth0)” section on page 5-10 through the
“Evaluate System Activity and Performance” section on page 5-48.