Installation guide

3-11
Cisco 6260 Hardware Installation Guide
OL-2365-02
Chapter 3 Installing a Cisco 6260 with a POTS Splitter Configuration
Installation Procedures
Figure 3-6 Positioning the Power and Ground Terminals to Accept Wires
Step 5 Insert the end of the grounding wire into the grounding receptacle, which is the bottom receptacle in the
terminal block on the PEM (see Figure 3-7). The stripped part of the wire must be fully inserted into the
terminal block so that no bare wire is exposed.
Step 6 Ensure that no wire strands are left outside the connector.
26693
INPUT OK
OUT FAIL
FAN TRAY 1
FANTRAY 2
INPUT OK
OUT FAIL
FAN TRAY 1
FANTRAY 2
Correct
terminal
position
(open)
Incorrect
terminal
position
(closed)