Installation guide

FIGURES
ix
Cisco 6260 Hardware Installation Guide
OL-2365-02
Figure 1-1 Cisco 6260 Chassis Components 1-2
Figure 1-2 Inverse Multiplexing and Recombining of ATM Cells Through IMA Groups 1-5
Figure 1-3 Subtended Network Configuration with DS3/2DS3 NI-2 Cards 1-8
Figure 1-4 Subtended Network Configuration Using DS3+T1/E1 IMA NI-2 Cards 1-9
Figure 1-5 Daisy Chain Topology for OC-3c Interfaces 1-10
Figure 1-6 Cisco 6260 Card Slots 1-12
Figure 1-7 Cisco 6260 Champ Connectors 1-13
Figure 1-8 4xDMT Faceplate 1-14
Figure 1-9 4xDMT over ISDN Faceplate 1-16
Figure 1-10 4xflexi Faceplate 1-18
Figure 1-11 4xSDSL Faceplate 1-20
Figure 1-12 8xDMT Faceplate 1-22
Figure 1-13 8xDMT Over ISDN Faceplate 1-24
Figure 1-14 8xG.SHDSL Faceplate 1-26
Figure 1-15 8xG.SHDSL Deployment in the Cisco 6260 System. 1-29
Figure 1-16 DS3/2DS3 NI-2 Card Faceplate 1-31
Figure 1-17 DS3+T1/E1 IMA NI-2 Card Faceplate 1-34
Figure 1-18 OC-3c/OC-3c NI-2 Card Faceplate 1-37
Figure 1-19 E3 I/O Module 1-42
Figure 1-20 E3 I/O Module 1-43
Figure 1-21 OC-3c I/O Module 1-43
Figure 1-22 I/O Module Wire-Wrap Pins Close-Up 1-44
Figure 1-23 PEM Faceplate 1-46
Figure 1-24 Cisco 6260 Fan Tray 1-47
Figure 1-25 Air Filters 1-48
Figure 2-1 Air Flow Through Intake and Exhaust Vents on the Cisco 6260 Chassis. 2-13
Figure 3-1 Mounting Options for Ear Brackets 3-4
Figure 3-2 Screw the Mounting Aids to the Rack 3-5
Figure 3-3 Mounting Aids Support the Chassis During Installation 3-6
Figure 3-4 System Ground Connection 3-8
Figure 3-5 Strip and Square Off Power and Ground Wires 3-10