Installation guide

2-16
Cisco 6260 Hardware Installation Guide
OL-2365-02
Chapter 2 Preparing for Installation
Required Tools and Equipment
2.3 Required Tools and Equipment
Table 2-4 lists the tools and equipment you need to install and connect the Cisco 6260
system components as detailed in Chapter 3, “Installing a Cisco 6260 with a POTS
Splitter Configuration,” and Chapter 4, “Installing a Cisco 6260 Without a POTS
Splitter Configuration.”
Table 2-4 also lists the tools and equipment you need to remove and install the Cisco 6260 system
components as detailed in Chapter 6, “Upgrading and Maintaining the Cisco 6260 System.”
Table 2-4 Tool and Equipment Requirements Checklist
Check Tools and Equipment
Hardware Components
Cisco 6260 chassis
Line cards (if not already installed in the Cisco 6260 chassis)
• 4xDMT
• 4xDMT over ISDN
• 4xflexi
• 4xSDSL
• 8xDMT
• 8xDMT over ISDN
• 8xG.SHDSL
NI-2 card(s) (if not already installed in the Cisco 6260 chassis)
• DS3/2DS3
• DS3+T1/E1 IMA
• OC-3c/OC-3c SMF
1
or MMF
2
I/O module (if not already installed in the Cisco 6260 chassis)
• E3
• E1
• OC-3c
Blank faceplates
Fan trays (if not already installed in the Cisco 6260 chassis)
PEMs (if not already installed in the Cisco 6260 chassis)
Champ cables
Third-party vendor POTS splitter
3
Software Components
•
Cisco IOS
• CDM
4
Tools
A 3/16-inch flat-head screwdriver
A Phillips-head screwdriver