Installation guide

1-25
Cisco 6260 Hardware Installation Guide
OL-2365-02
Chapter 1 Product Overview
Cisco 6260 System Overview
1.2.3.7 Octal-Port G.SHDSL SHTU-C Line Card Overview
The octal-port G.SHDSL SHTU-C line card (8xG.SHDSL)
• Supports eight SHDSL modem connections
• Supports trellis coded pulse amplitude modulation (TC-PAM) line encoding
• Converts G.SHDSL modulation from the line into digital data streams to and from the NI-2 card
• Supports fixed and adaptive rate modes
• Has deployment guidelines when used in the Cisco 6260 system; see the “Guidelines for Intermixing
8xG.SHDSLs—Cisco IOS Release 12.2(7)DA and Later” section on page 1-28.
Note For hardware specifications for the 8xG.SHDSL line card, see the “Octal-Port G.SHDSL SHTU-C Line
Card” section on page A-7.
ATU-C 2 Green solid
Green blinking
Off
Modem 2 is trained.
Training is in progress for modem 2.
Modem 2 is idle.
ATU-C 3 Green solid
Green blinking
Off
Modem 3 is trained.
Training is in progress for modem 3.
Modem 3 is idle.
ATU-C 4 Green solid
Green blinking
Off
Modem 4 is trained.
Training is in progress for modem 4.
Modem 4 is idle.
ATU-C 5 Green solid
Green blinking
Off
Modem 5 is trained.
Training is in progress for modem 5.
Modem 5 is idle.
ATU-C 6 Green solid
Green blinking
Off
Modem 6 is trained.
Training is in progress for modem 6.
Modem 6 is idle.
ATU-C 7 Green solid
Green blinking
Off
Modem 7 is trained.
Training is in progress for modem 7.
Modem 7 is idle.
ATU-C 8 Green solid
Green blinking
Off
Modem 8 is trained.
Training is in progress for modem 8.
Modem 8 is idle.
Table 1-8 8xDMT over ISDN LED Indicators (continued)
LED State Function