Installation guide

A-10
Cisco 6260 Hardware Installation Guide
OL-2365-02
Appendix A Technical Specifications
Hardware Specifications
A.1.11 OC-3c/OC-3c NI-2 Card
Table A-11 lists the specifications of the single-mode and multimode versions of the OC-3c/OC-3c
NI-2 card.
Transmission distance E1—Short haul: 0 to 655 feet (0 to 199.64 meters),
long haul: > 655 feet (199.64 meters)
no span power
Power consumption 32.5W
Minimum software and
network management
requirement
Cisco IOS—Release 12.1(7)DA
CDM—Release 3.3(3) (optional)
1. All external interfaces for the DS3+T1/E1 IMA NI-2 card are located on the I/O module.
2. All trunk and subtend connectors for the DS3+T1/E1 IMA NI-2 card are located on the I/O module.
Table A-10 DS3+T1/E1 IMA NI-2 Card Specifications (continued)
Specification Description
Table A-11 OC-3c/OC-3c NI-2 Card Specifications
Specification Description
Internal hardware 150 MHz RC64475 CPU
Galileo GT64120 system controller
1 M x 32 bootflash
1
(4 MB)
4 M x 32 Flash
512 KB boot EPROM
Dimensions Height: 12.38 in. (31.45 cm)
Depth: 8.50 in. (21.59 cm)
Width: 1.80 in. (4.57 cm)
Weight 3.0 lb (1.36 kg)
Layer 2 protocol ATM
Power consumption 33.5W
Minimum software and
network management
requirement
Cisco IOS—Release 12.0(5)DA
2
CDM—Release 3.0 (optional)
Single Mode Card Multimode Card
External interfaces Two OC-3c/STM-1 (155 Mbps)
single-mode ports
Two OC-3c/STM-1 (155 Mbps)
multimode ports
Connector type SC-PC SC-PC
Fiber type Intermediate reach single mode Multimode
Average transmitted power –15 to –8 dBm –20 to –14 dBm
Average received power –8 dBm –11 dBm
Transmission distance Up to 20 km (12 miles) Up to 2 km (1.2 miles)
Wavelength 1310 nm 1300 nm