Installation guide

6-7
Cisco 6260 Hardware Installation Guide
OL-2365-02
Chapter 6 Upgrading and Maintaining the Cisco 6260 System
Installing and Replacing Hardware
6.3.1 xTU-C Line Card
The following sections describe how to remove and replace or install an xTU-C line card.
6.3.1.1 Installing an xTU-C Line Card
Complete the following steps to install the xTU-C line card in the chassis.
Note It is important that you complete each step before moving on to the next step.
Step 1 Connect a grounding strap to the ESD grounding jack that is located on the top right of the Cisco 6260
card cage.
Step 2 Hold the xTU-C line card vertically, with the line card faceplate toward you and the connectors facing
the chassis slot.
Step 3 Align the upper and lower edges of the xTU-C line card with the upper and lower guides in the
chassis slot.
Step 4 Lift up on the ejector lever and gently apply pressure to the bottom of the faceplate while pushing the
line card into the slot.